The anvil hole is too big
If the anvil hole is too large you will experience poor torque out and push out performance.
All of our products are manufactured for reliability and consistently high quality and are RoHS compliant as standard.
Our bright zinc based platings are all high quality trivalent clear chromate based finishes.
Poor performance - (part not fully installed)
Poor performance - (part not installed squarely)
Poor performance - (wrong hole size punched in panel)
Poor performance - (hole has been deburred)
Tight Threads - (part has been over installed)
Part is cracking on installation - (wrong shank length used)
Stud is buckling panel - (need countersink in anvil)
Head of fastener is cupping - (punch is too narrow)
Poor performance - (hole in anvil is too wide)
Self Clinching Fastener Installation Guides
Self Cinching Fastener Performance Data
Self Clinching Fasteners Do's and Don'ts
Centerline to edge problems
Plating Info
Galvanic Corrosion Info
Hardness conversion chart
Fastener & Application Testing
Design & Development of bespoke Fasteners
If the anvil hole is too large you will experience poor torque out and push out performance.
