First punch or drill the correct size hole. DO NOT deburr the hole prior to installation as this will remove material required during the clinching process. It is preferable to install the fastener from the side of the panel with the burring or blow through.

Place the fastener in the hole like in the diagram above making sure the part is seated squarely.

Apply a parallel squeezing force until the hexagon head is installed flush in the panel.

When installing Self Clinching fasteners, please pay attention to the minimum hole centerline to edge and parent material hardness limitations.

For special applications or if you are unsure of any aspect about the usage or installation of this fastener, give our sales office a call and we will do our best to offer you a solution or give advice on your application. Tel: +44 (0) 1302 836010 e-mail: sales@npfasteners.com

A list of common installation problems and solutions for Self Clinching fasteners can be found here.